Bad wiring could lead to a life or death situation depending on your excursion’s location and climate. Use the same path as the manufacturer to play it safe when moving your wires.įaulty wires mean that certain parts, or all, of your machine, could stop working. If there are places on the machine that will generate more heat or have a higher risk of rubbing on exposed wires, it is best to move the cables away from them. ![]() One of the most important things to look for when moving the harness is heat spots. Guide the Wiring Harness to the Rear of the Side-by-Side Take care not to snip or pull apart any wires until you know their function. ![]() Once the seats are gone, you can unbolt the console and reveal the mess of wires on the inside. The plastic flooring is interconnected and is held by a series of bolts and plastic grommets that can be a pain to undo. The seats on the inside will need to be removed. The mess of cables can seem daunting but rest assured they all have a purpose and function. Follow these wires inside and under the center console of the vehicle. This harness holds the wiring essential for the functioning of the UTV and some extra spots for accessories. On the front of the UTV is a large plastic covering that houses the main wiring harness. Headlights/spotlights Remove the Front Hood Plastic and Seats.Required UTV lighting for driving on the streets includes: If there is an emergency, a good lighting set can alert authorities. These lights provide the driver and rider the appropriate amount of safety while showing your place on the road or trail to other riders. The laws vary depending on the state, but typically, all UTVs should have working front and rear blinkers, taillights, and tag lights. More popular UTV models will have a large online following, and users are always open to answer questions. If there isn’t, check a few discussion boards to see what other owners are using. Browse through the owner’s manual and see if there is a system that the manufacturer suggests. Choose an Appropriate Lighting System for Your UTVĭepending on the model and kind of side-by-side you own, there may be a specific type of lighting kit for your machine. Conclusion Steps to Install Turn Signalsīelow we describe a little more about how to perform the steps to install turn signals.Top 6 Turn Signal Systems for Side-by-Side UTVs.Return the Plastic Pieces to their Places on the UTV’s Body.Connect the Color-Coded Wiring to the New Lights. ![]() Install the Dash Electronics and Lights.Drill Holes and Replace with New Light System.Measure the Areas for the Blinkers and Tail Lights.Guide the Wiring Harness to the Rear of the Side-by-Side.Remove the Front Hood Plastic and Seats.Choose an Appropriate Lighting System for Your UTV.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |